Novamatic FH68-VCU Manual de usuario Pagina 18

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 28
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 17
2. Pull the rear end of the shelf support
away from the side wall and remove it.
2
1
Install the shelf supports in the opposite
sequence.
Removing and installing the
oven glass panels
You can remove the internal glass panels to
clean it. The number of glass panels is
different for different models.
WARNING! Keep the oven door
slightly open during the cleaning
process. When you open it fully
it may accidentally close causing
potential damage.
WARNING! Do not use the
appliance without the glass
panels.
1. Open the door until it is at an angle of
approximately 30°. The door stands
alone when slightly open.
30°
2.
Hold the door trim (B) at the top edge of
the door on both sides and push
inwards to release the clip seal.
1
2
B
3.
Pull the door trim to the front to remove
it.
WARNING! When you take
out the glass panels the
oven door tries to close.
4. Hold the top edge of the door glass
panels and pull them up one by one.
5. Clean the glass panel with water and
soap. Dry the glass panel carefully.
When the cleaning is complete, install the
glass panels and the oven door. Do the
above steps in the opposite sequence.
Install the smaller panel first, then the larger.
CAUTION! The screen with a
printing on the inner glass panel
must face the inner side of the
door.
CAUTION! Make sure that after
installation the surface of the
frame of the glass panel on the
screen with a printing is not
rough when you touch it.
18
Vista de pagina 17
1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 27 28

Comentarios a estos manuales

Sin comentarios